Inverter Pulsar - Intended use

USER AND SAFETY INSTRUCTIONS
5
Pulsar extractor fan | Installation and operation instructions
Intented use
The Pulsar extractor fan (hereinafter referred to as
“Pulsar”) is used to ventilate rooms with external windows,
taking into account the technical data and applications
described in this manual, and only in conjunction with the
components recommended by inVENTer GmbH and which
are mentioned in this documentation.
Modications or conversions to the appliance are not
permitted.The Pulsar complies with the technical safety
requirements and standards for electrical appliances for
domestic use. It may only be set up and operated in
conjunction with this documentation.
Proper transport, storage and installation as well as careful
operation and maintenance are prerequisites for the fault-
less and safe operation of the appliance.
• Always observe the relevant standards, regulations and
guidelines when installing the equipment/system.
• The Pulsar is designed for permanent installation with
permanent wiring.
• CAUTION: The appliance may only be installed by
qualied personnel.
- Comply with the specications of protection class II
when laying the mains cable.
- Wire all the units in a ventilation system to the the
same circuit breaker.
- Only lay and connect cables when they are
disconected from the power supply!
- It must be ensured that the mains power supply
(voltage, frequency) corresponds to the specications
on the type plate.
- Before working on electrical installations, disconnect
all relevant devices from the power supply.
- Before drilling, check whether there are any there are
cables in the drilling area.
• DANGER: Observe the installation regulations according
to VDE 0100 when connecting in damp rooms.
- Attach the Pulsar solely outside the protected area 0.
( Chapter 3.1, Page 8).
- Do not use the Pulsar in places where direct contact with
splashing water is possible over a long period of time
and/or where the unit is exposed to direct jets of water
• WARNING: For the joint operation of a ventilation
device with replaces, safety measures must be taken
to prevent the development of negative pressure in the
building. The decision as to which measures should be
implemented is made by the responsible chimney sweep
and/or building planner.
• CAUTION: The appliance must not be operated by
children and/or persons who, because of their physical,
sensory or mental capabilities or inexperience or lack of
knowledge, are not capable of doing so safely. Young
children must be supervised to ensure that they do not
play with the appliance.
• NOTICE: Using too small a wire cross-section leads
to too high a voltage drop and/or contacting is not
guaranteed!
• NOTICE: Ensure su󰀩cient contacting of the lines when
connecting the Pulsar.
• NOTICE: Lay cables without a plaster-resistant cable
sheath in the empty conduit to avoid short circuits and/
or cable res.
• NOTICE: The device has plastic surfaces that are sensi-
tive to scratches. Do not touch components with oily and/
or dirty hands. Avoid contact with sharp or pointed objects.
• Ensure su󰀩cient air supply in the room, for example by a
large gap under the door
• The exhaust air fan may only be put into operation after
completion of the construction work.
If your device has a defect, contact your factory representa-
tive or our technical service.