involight TRINITY200LED - Page 31

30
Channel
Pan
0-255
"Channel control" operating mode
The "Manual control" mode can only be activated if the
device is working alone or is the master in a master-
slave combination. This setting is only relevant if the
device is not controlled by DMX.
a) Press the (Enter) key until “chanel control” is
displayed.
b) To select the desired parameter, press the ▲ (Up) or
▼ (Down) button.
c) Press (OK) to edit the values.
d) Press the ▲ (Up) or ▼ (Down) buttons to select the
value between "0" and "255".
e) Press the (OK) button to confirm and exit the menu.
f) Press the (Return) key to exit the selection without
saving.
Tilt
0-255
Dimmer
0-255
Strobe
0-255
Cyan
0-255
Magenta
0-255
Yellow
0-255
Color1
0-255
Color2
0-255
Color3
0-255
Fixed-Gobo
0-255
Rot-Gobo
0-255
Rot-Gobo
Rot
0-255
Effect
0-255
Prism1
0-255
Prism1 Rot
0-255
Prism2
0-255
Prism2 Rot
0-255
Effect
0-255
Focus
0-255
Prism1
0-255
Prism1 Rot
0-255
Prism 2
0-255
Prism 2 Rot
0-255
System
Language
Language selection
Display
Normal
Invert display (for example in flight operations).
a) Press the (Enter) key until "Display" appears.
b) To select the desired mode, press the ▲ (Up) or ▼
(Down) button.
c) To confirm and exit the menu, press the (OK) key
d) Press the (Return) key to exit the selection without
saving.
Invert
Backlight Setting
Auto
Display lighting (The display goes dark after 15
seconds without pressing a button or is always on.)
a) Press the (Enter) key repeatedly until the display
shows "Settings".
b) Press the ▲ (Up) or ▼ (Down) button until "On" or
"Off" is displayed.
c) To confirm and exit the menu, press the (OK) key
d) Press the (Return) key to exit the selection without
saving.
Keep on
Factory Reset
Reset to factory settings
Device TOU(Min)
Show device information
Fans Voltage
Fan voltage information
Error record
Error recording information
About
Displays the current software version