INVT GD300-5R5G-4

Goodrive300 Series VFD Function parameters
96
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
LED tens: frequency control selection
0: Only valid when P00.06=0 or P00.07=0
1: All frequency means are valid
2: When the multi-step are priority, it is invalid to
the multi-step
LED hundreds: action selection when stop
0: Setting valid
1: Valid in the running, clear after stop
2: Valid in the running, clear after receiving the
stop commands
P08.45
UP terminals
frequency
changing ratio
0.01–50.00Hz/s
0.50
Hz/s
○
P08.46
DOWN
terminals
frequency
changing ratio
0.01–50.00 Hz/s
0.50
Hz/s
○
P08.47
Frequency
setting at
power loss
0x000–0x111
LED ones: Action selection when power off.
0: Save when power off
1: Clear when power off
LED tens: Action selection when Modbus set
frequency off
0: Save when power off
1: Clear when power off
LED hundreds: The action selection when other
frequency set frequency off
0: Save when power off
1: Clear when power off
0x000
○
P08.48
High bit of
initial power
consumption
This parameter is used to set the original value of
the power comsumotion.
The original value of the power comsumotion
=P08.48×1000+P08.49 (kWh)
Setting range of P08.48: 0–59999 kWh (k)
Setting range of P08.49: 0.0–999.9 kWh
0 kWh
○
P08.49
Low bit of
initial power
consumption
0.0 kWh
○
P08.50
Magnetic flux
braking
This function code is used to enable magnetic
flux.
0
●