Goodrive300 Series VFD Function parameters
118
Detailed instruction of parameters
0x00–0x11
LED ones:
0: Write with response: the VFD will respond to all
reading and writing commands of the upper
monitor.
1: Write without response: the VFD only responds
to the reading command other than the writing
command of the drive. The communication
efficiency can be increased by this method.
LED tens:
0: Communication encrypting is invalid
1: Communication encrypting is valid
P15 Group PROFIBUS/CANopen function
0: PROFIBUS
1: CANopen
Select communication protocol
0–127
This function code is used to designate the
address of the VFD.
Note: 0 is the broadcast address, when set it as
broadcast address, only receive the radio
command of the upper monitor other than
answering the upper monitor.
0: Invalid
1: Setting frequency (0–Fmax(unit:0.01Hz))
2: PID reference, range (0–1000, 1000
corresponds to 100.0%)
3: PID feedback, range (0–1000, 1000
corresponds to 100.0%)
4: Torque setting (-3000–3000,1000 corresponds
to 100.0% the rated current of the motor)
5: Upper frequency of forward rotation (0–Fmax
unit:0.01Hz))
6: Upper frequency of reverse rotation
(0–Fmax(unit:0.01Hz))
7: Electromotion torque upper limit (0–3000,1000
corresponds to 100.0%of the rated current of the
To Next Page
Loading...
Need help?
General