ION PATHFINDER GO User Manual

ION Audio Pathfinder
TM
Go User Guide 11
Bluetooth Connecting with Pathfinder
TM
Go
1. Turn on Pathfinder
TM
Go by holding down the Power button for 2 seconds. Pathfinder
TM
Go will automatically enter Bluetooth pairing mode.
2. Navigate to your device’s Bluetooth setup screen, find P
athfinder Go, and connect. The
B
luetooth icon will appear in the display, and you will hear “Connected” (if voice prompts
are enabled).
Note: Do not connect to iSP165_BLE; this is reserved exclusively for connecting to the ION
Sound Control
TM
app. If you experience trouble in connecting, select “Forget this Device”
on your Bluetooth device and try to connect again.
3. Now you can use the buttons on the front panel to control audio playback:
• Press the P
lay/Pause button to play or pause the current track.
• Press and quickly release the +
button to increase the volume.
• Press and quickly release the -
button to decrease the volume.
• Press the >
button to skip to the next track.
• Press the <
button to revert to the beginning of the current track. Repeat this action
within 1 second to skip to the previous track.
T
o disconnect a paired device, do any of the following:
• Turn o Bluetooth from your device’s Bluetooth settings. The speaker will enter
Bluetooth pairing mode to make it available for another device.
• Double-press the Bluetooth button to disconnect and re-enter pairing mode.
• Briefly press the Bluetooth button to disconnect and enter Aux mode.
When you disconnect a Bluetooth device, you will hear “Bluetooth disconnected” if voice
prompts are enabled.
OPERATION
1 - PRESS AND HOLD
2
PATHFINDER
TM
GO

ION PATHFINDER GO Specifications

General

Power Output	50W
Water Resistance	IPX5
Bluetooth	Yes
Built-in Microphone	Yes
USB Charging Port	Yes
Inputs	1/8-inch (3.5mm) aux input
Bluetooth Range	Up to 100 ft (30.5 m)