ION PATHFINDER GO User Manual

ION Audio Pathfinder
TM
Go User Guide 8
4
. Source Button
Press this button to cycle between FM, USB, and Aux modes.
5
. Lights Button
Press this button to switch between Color Cycle, Beat Sync, and Solid Color light modes, or
to turn the lights o.
6
. Stereo-Link
TM
/ Repeat Button
See O
peration > Stereo-Link
TM
: Syncing Two Speakers to learn more.
In USB playback mode, press this button to cycle between repeat modes. See O
peration >
U
SB Playback Mode to learn more.
7
. Previous / Next Buttons
In FM mode, press these buttons briefly to go to the previous or next station. Press and hold
these buttons to seek the previous or next strong station.
In Bluetooth and USB modes, press the Previous or Next buttons to go to the beginning of
the current track or skip to the following track, respectively. Press the Previous button again
within one second to skip to the previous track.
8
. Play/Pause / Presets Button
Press this button to play and pause Bluetooth or USB audio.
In FM mode, use this button to save and recall radio presets. See O
peration > Using the
R
adio to learn more.
9
. Volume Up/Down Buttons
Press these buttons to adjust the speaker’s volume. The current volume level will be shown
on the display.
Press and hold both + and – buttons for 5 seconds to reset the speaker to factory settings.

ION PATHFINDER GO Specifications

General

Power Output	50W
Water Resistance	IPX5
Bluetooth	Yes
Built-in Microphone	Yes
USB Charging Port	Yes
Inputs	1/8-inch (3.5mm) aux input
Bluetooth Range	Up to 100 ft (30.5 m)