e
CORNERMATIC PLUS
WARNING
MESTEK MACHINERY has conduct hazard evaluation and risk analysis studies for their
product. Safe guards installed on the equipment are there for a reason. BEFORE
EQUIPMENT IS PLACED INTO SERVICE, ALL SAFE GUARDS OR DEVICES MUST BE IN
PLACE AND PROPERLY ADJUSTED.
Maintenance
Before performing any maintenance on a piece of equipment, insure that all power is
locked off in accordance with your company’s lockout/tagout policy. Be sure that all
movable members (such as rolls, arms, tables, etc.) are securely blocked from
inadvertent motion which might be hazardous. Treat all electrical lines as being live
and all Mestek Machinery as being under high pressure. Ensure that all items are
properly reassembled before placing them into operation. Before equipment is
returned to service, ALL safe guards or devices MUST BE in place and properly
adjusted.
NOTICE
Before doing any WELDING ON EQUIPMENT, the following precautions must
be taken to insure against damage:
1) All power is removed from system.
2) The weld ground is connected to the closest possible location on the unit
where the welding is being performed.
3) All encoders, sense eyes, and controls should be electronically
disconnected if at all possible to avoid possible damage.
Operation
This equipment is capable of speeds, tensions, and adjustments which may be
hazardous for some of the materials within the line specification. For example, thin,
narrow strip may be subjected to tensions sufficient to cause breakage. Never
attempt to process any material unless the safe adjustments for that particular are
known and can be implemented.
Traffic Around Equipment
Care should be taken at all times in moving around the equipment, whether on foot or
in a vehicle. Changes in floor elevation, machine bases and debris around the
equipment are trip hazards. Take care that personnel are not trapped between
vehicles and equipment.
WARNING
Do not attempt to walk or climb on any machine while in operation. Failure to observe this
warning may result in death or serious injury.
HAZARD REMINDER
Use the following HAZARD REMINDER sheet to reinforce awareness of the hazards
associated with coil processing lines. This reminder can be a useful supplement to your
company’s safety program. MESTEK MACHINERY suggests the following steps:
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
To Next Page
Loading...