iPECS ES-3052GP - Page 36

F IGURES
– 36 –
ES-3052 Series
Figure 176: Configuring an Extended IPv4 ACL 330
Figure 177: Configuring a Standard IPv6 ACL 332
Figure 178: Configuring an Extended IPv6 ACL 334
Figure 179: Configuring a MAC ACL 336
Figure 180: Configuring a ARP ACL 338
Figure 181: Binding a Port to an ACL 340
Figure 182: Configuring Global Settings for ARP Inspection 343
Figure 183: Configuring VLAN Settings for ARP Inspection 345
Figure 184: Configuring Interface Settings for ARP Inspection 346
Figure 185: Displaying Statistics for ARP Inspection 347
Figure 186: Displaying the ARP Inspection Log 348
Figure 187: Creating an IP Address Filter for Management Access 350
Figure 188: Showing IP Addresses Authorized for Management Access 350
Figure 189: Setting the Maximum Address Count for Port Security 352
Figure 190: Configuring the Status and Response for Port Security 353
Figure 191: Configuring Port Security 354
Figure 192: Configuring Global Settings for 802.1X Port Authentication 356
Figure 193: Configuring Interface Settings for 802.1X Port Authenticator 360
Figure 194: Configuring Interface Settings for 802.1X Port Supplicant 362
Figure 195: Showing Statistics for 802.1X Port Authenticator 364
Figure 196: Showing Statistics for 802.1X Port Supplicant 365
Figure 197: Setting the Filter Type for IP Source Guard 367
Figure 198: Configuring Static Bindings for IP Source Guard 368
Figure 199: Displaying Static Bindings for IP Source Guard 369
Figure 200: Showing the IP Source Guard Binding Table 370
Figure 201: Configuring Global Settings for DHCP Snooping 374
Figure 202: Configuring DHCP Snooping on a VLAN 375
Figure 203: Configuring the Port Mode for DHCP Snooping 376
Figure 204: Displaying the Binding Table for DHCP Snooping 377
Figure 205: Setting Action for Packets with Layer 4 Port Set to Zero 378
Figure 206: Configuring Settings for System Memory Logs 381
Figure 207: Showing Error Messages Logged to System Memory 382
Figure 208: Configuring Settings for Remote Logging of Error Messages 383
Figure 209: Configuring General Settings for SMTP Alert Messages 385
Figure 210: Specifying SMTP Servers 386
Figure 211: Showing Configured SMTP Servers 386