iPECS LIP-8002E - Page 48

LIP-8002E/2AE User Guide
42
To access Network settings:
• Press TRANS/PGM button and search (Network) or (Network
Settings) – Dial ‘78’(iPECS-LIK) / ‘38’(iPECS SBG-1000) /
‘80’(iPECS-MG) or press
TRANS/PGM button more than 2
seconds in iPECS-LIK or iPECS SBG-1000.
• Enter the password (default=147*); the following will display:
MFIM #[1/2] ?
MFIM #1 - CHANGE[#]
• Press the # key to toggle between multiple profiles (MFIM),
• Press the VOL ▲▼ buttons to advance to the next network
configuration item,
• Press the HOLD/SAVE button to save each setting.
To set LLDP:
• In Network Config. Menu, use VOL   buttons to locate the LLDP
configuration screen (shown),
LLDP?
[ENABLED] – CHANGE [#]
• Enable in LLDP? menu and press the Hold/Save button.
To set default Config. settings:
• In Network Config. Menu, use VOL   buttons to locate the
Default Config. Screen (shown),
SET DEFAULT CONFIG(DOT:*)
• Press the * key.
To exit Config. settings:
• Press the SPEAKER button,
• Press the * key to exit,
OR
• Press the # key to Reset/Reboot the phone with new setting.