LIP-8002E/2AE User Guide
3
DND – Blocks all incoming calls.
Speed – Access speed dialing, speed programming.
Vol – Adjusts volume for ringing, headset, and
speakerphone; adjusts LCD brightness.
Trans/PGM – Call transfer, or programming mode.
Hold – Places active call on hold or saves programming
information.
Call Back – Initiates call back request when calling a
busy station; call is completed when busy station returns
to idle status.
Speaker – Allows User to place a call while on-hook.
Toggle to activate.
Flexible – Some are system pre-programmed for line
appearance, and some are user programmable.
Ring/MSG Indicator – Illuminates when ringing, or
message waiting.
LCD Display – Phone interface for status, dialing
directories, and text message information.
Hands-free Microphone – Used for hands-free
speakerphone function.
1.5 LIP-8002E/2 AE Phone Installation
The LIP-8002E/2AE can be connected to any standard
10/100 Base-T Ethernet switch port. When the LIP-
8002AE is connected to an 802.3af compliant switch
port (ex., POE8), The LIP-8002E/2AE obtains power
from the Ethernet port. When LAN power is available,
do not use AC/DC adaptor. When LAN power is not
available, the AC/DC adaptor must be used. The
following image shows how to connect the handset,
power cord, and LAN cable to the phone.(The LIP-
8002AE isn’t support PoE and can use only the supplied
adaptor)
To Next Page
Loading...
