WIT-400HE Installation Manual
Date: 15/M ar/2012
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of Ericsson-LG Co.Ltd.
14
message is affected by the DTIM parameter.
Beacon is an indication of packets buffered in AP which are to be delivered to each wireless station, WIT-
400HE. The information of DTIM is contained in a beacon message. Therefore, DTIM configuration can
be affected by the beacon interval. The following is illustrating the relationship of beacon and DTIM:
Recommendation)
(1) DTIM should be less than 200 msec.
(2) If AP doesn’t support DTIM configuration, more special care needs to be taken for Beacon
interval setup. Otherwise, Use the smallest DTIM interval that AP can support.
2.3.3 Configuration
This section enumerates how you set up both SSID and DTIM in AP.
Cisco
(1) Open a page “Network Interfaces > Settings” . You can see a edit box “DTIM”.
(2) Enter 3.
WIT-400HE
To Next Page
Loading...
