iPECS WIT-400HE - Starting Diag. Server of WIT-400 HE; Check Diag Setting

WIT-400HE Installation Manual
Date: 15/M ar/2012
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of Ericsson-LG Co.Ltd.
21
3) Press “OK” to set debug.
4) Press “Send”(Soft Right Menu) to send debug information.
- Server IP : PC IP address which wit400trace.exe is running.
- Server TCP Port : TCP port of the application
5) Press “Send”(OK) to send
- It takes around 20 seconds to get the data.
- If it fails, check the network configuration of PC and WIT-400HE.
- If WLAN of WIT-400HE is not connected, you can use USB cable.
4.2 Starting Diag. Server of WIT-400HE
4.2.1 Check Diag Setting
1) Run windows “command prompt”
2) Move to the directory “c:\WIT-400H”, where “wit400h_diag.exe” exists.
- You can change to any other directory.
3) Try “ping” to the IP address of WIT-400HE.
- If replies, go to next step.
- If not, check the network configuration of PC and WIT-400HE.