IPS Controllers M720 - Installati; Setup; Tools; Procedure

II. Installaon
A. Setup
1. Turn o all peripheral equipment such as heaters, chemical
feeders, and pumps.
2. Relieve pressure from the ltraon system.
B. Tools
1. Cordless drill
2. 1/4” NPT Tap
3. 7/16” drill bit
4. Masonry drill bit and anchors, or other appropriate fasteners
5. 13/16” wrench or channel-lock pliers
C. Procedure
1. Locaon
a. Wall area with easy access
b. Within 8 feet of feeder
c. At least 10 feet from water edge
d. Close proximity to me clock
e. Within 6 feet of GFCI power source
2. Mounng
Note: The controller and ow cell are factory mounted to the ABS
board for convenience.
a. Securely mount ABS mounng board with M720 controller
and ow cell on wall (vercal installaon).
b. If applicable, securely aach the peristalc pump with the
provided hardware.
11
M720 pH/ORP Controller Owner’s Manual