IPS 555ES - To Repeat the Length Previously Dispensed (Standard Model); To Repeat the Length Previously Dispensed (Automatic Model)

Better Packages Section 2
Operation
17
REPEAT
START
REPEAT
START
REPEAT
START
REPEAT 2
ENTER
REPEAT 2
ENTER
6
9
TO REPEAT THE LENGTH PREVIOUSLY DISPENSED (STANDARD MODEL):
The dispenser “remembers” the last length of tape dispensed and stores that value in its memory.
Pressing the REPEAT key dispenses the same length of tape that was previously dispensed. This is
especially handy if you are dispensing a tape length that was adjusted using the or the buttons.
The REPEAT key also repeats standard number button lengths. Each time you dispense a different length
of tape by pressing a different button or combination of buttons, that new figure:
• Is stored in the REPEAT button memory
• Becomes the length dispensed the next time you press the REPEAT button.
The REPEAT Button –
Lower left on the keyboard
TO REPEAT THE LENGTH PREVIOUSLY DISPENSED (AUTOMATIC MODEL):
The dispenser “remembers” the last two length of tape dispensed and stores those values in its memory.
STANDARD MODE:
To dispense a six inch tape press once. Remove the piece of tape.
Press this will also dispense a six inch tape.
Press and a nine inch piece of tape will be dispensed. Remove the piece of tape.
Press a nine inch piece of tape will again be dispensed.