19
Programming mode 4
Programming
To get into the "programming mode": see Classifications according to modes 2.
The selection here is generally made by altering, if necessary, the command on the display by means of
" NO " ( e . g . " no HECo " becomes " HECo " after pressing " NO "). Confirm this selection with " E ". While
programming, it is possible to return step by step by pressing the " STOP " button.
ProG (flashing) = Programming
Press " E "
ProG XX = The program number that is to be programmed
Put in the required program number with " X,X ".
The led in the button of the selected number on the keyboard will light up. If a program number higher than 9
is selected, press the number followed by " +10 " or " +20 ". Press " E " once more.
The next step depends on the selection during "preprogramming".
- With " no Coin " (without coin meter): transition to " XX.id XX ".
- With " Coin " (with coin meter): transition to " Coin ".
Coin = Amount due for the wash program
Press " E " and then put in the amount with " X,X,X,X ".
If necessary, move the decimal point by pressing " START ".
Press " E " once more.
By pressing " STOP ", it is possible to return to " ProG XX " to change the price of another program.
By pressing " STOP " once more, one can immediately proceed to " StArt ". This enables you to modify the
amount without running through the entire program.
XX.id XX = " Program number " and " Number of program segment ".
The first XX stands for the program number which is put in with " ProG ".
The second XX stands for the number of the segment of the program.
Example:
" 02.id 03 " stands for program 2, segment 3 in this program.
A segment is a part of a program (prewash, main wash, rince, etc.) and always ends with a drain. So in order
to obtain a complete wash cycle, different segments of a program must be put in one after the other. (maximum
99 per wash cycle)
Put in the number of the segment with " X,X " and press " E ".
Should there be insufficient space in the Ram memory, the error message " Ram full " will appear.
XX. CYt i = Cycle time
This is the duration of the wash time for this segment (XX) of the program (without taking into account the
temperature and level controls).
From now on, XX stands for the number of the program segment that was put in.
Press " E ".
t XX = Time (wash time in minutes)
Put in the time with " X,X " ( from 0 to 60 minutes) and press " E ".
If " 0 " was put in, the program immediately skips to " SPin " ( or " no SPin ").
XX. rotE = Rotation (Pause and cycle times)
Press " E ".
To Next Page
Loading...