Copying mode 5
Copying mode
To get into the copying mode: see chapter Classification according to modes 2.
The PC 30 microprocessor is provided with 10 standard programs (30 to 39). These programs can be immediately
implemented.
On these places they cannot be modified. To modify them or to use them as structure for another program, you must
first copy them to a program number between 0 and 29. See further.
Other self-made programs can be copied the same way to other numbers (between 0 and 29) so you can use them
as a structure for a new program. This saves a lot of time when you want to program various simular programs.
CoPY PrG = Copy program
To confirm press " E ".
To cancel press any other key. (Transition to " StArt ")
SourCE.XX = Program to be copied
Put in the number of the program to be copied with " X,X " and confirm with " E ".
dESt .YY = Destination (destination of the copied program)
Put in the number of the program with " Y,Y " and confirm with " E ".
XX .... YY = Confirmation of copying
To confirm, press " E ". (Transition to " StArt ")
To cancel, press any other key. (Transition to " StArt ")
In case there isn't enough space left in the Ram memory, the error detection " Ram full " will appear.
To Next Page
Loading...