To Next PageTo Next Page
Need help?Do you have a question about the IPSO PC30 and is the answer not in the manual?
Overview of machine capabilities and programming features.
Explanation of symbols used in the manual's flow charts.
Initializing machine technical specifications and options.
Step-by-step data input for creating wash cycles.
Copying existing programs to new numbers.
Starting and running programmed wash cycles.
Setting machine technical specifications and freely programmable options.
Technique for controlled water feeding and mixture.
Temporarily stops program during water heating.
Switches drum action/stop times during heating.
Settings for program end buzzer and temperature display.
Rapid program execution and emergency stop functions.
Alarm function and spin unbalance settings.
Introduction to programming mode and core commands.
Setting program number and price for coin-op.
Identifying segments and setting segment duration.
Setting wash time and pause/cycle times.
Setting cycle time and pause time.
Setting spin speed for programs.
Setting bath temperature and display units.
Settings for heating control and duration.
Drum action during heating and water inlet selection.
Setting up liquid soap injection for programs.
Configuring the first liquid soap injection.
Setting water level and control options.
Defining the water level at which the processor stops.
Cool-down, Stop, Soak, and Alarm settings.
Setting highest and lowest cool-down temperatures.
Configuring programmed stop and soak functions.
Alarm settings and disabling program extensions.
Configuring spin duration and speed.
Selecting drain valves 1 and 2.
Setting high spin duration, speed, and delay.
Configuring drain options and duration.
Wash action, distribution, jolt, and plain drain.
Setting the duration for a program segment.
Maximum segments and ending a program segment.
Setting tumble duration and alarm activation.
Display of checksum at end of programming.
Procedures for adding or removing program segments.
Reference to tables showing programmed data.
Steps to copy programs between numbers.
Initiating copy and selecting source program.
Setting copy destination and confirming.
Procedures for choosing and initiating wash programs.
How the selected program number is shown.
Setting a delay before program start.
Switching to a different program during operation.
Temporary modification of level, time, and temperature.
Reading bath temperature and drum speed.
Viewing segment status and remaining time.
Rapidly advancing programs and programmed stops.
Soak function and associated alarm settings.
Pausing program execution for a set time.
Using STOP button, adding/draining water.
Activating bath heating manually.
Adding soap manually during a program.
Troubleshooting common error indicators.
Showing total operating hours and received coins.
Procedure to access diagnostic tests.
Verifying status of 8 input contacts.
Verifying DIP switch settings for spin activation.
Testing coin meters and water level sensor.
Testing temperature sensor and 24 output contacts.
Testing keyboard and erasing program memory.
Physical connection of liquid soap hoses.
Connecting pump wiring to the control board.
Reference to program details on the next page.
General