25
Programming mode 4
SoAP = Liquid soap injection
If soap injection is not desired, select " no SoAP " and press " E ". (Transition to " XX. SE-L ")
If soap injection is desired, select " SoAP " and press " E ".
SoI = Liquid soap injection 1
Choose with " NO " wether an inlet valve should be selected or not.
Then press " E ".
t1. XXX = Time 1 (Duration of the soap injection 1)
Put in the duration (maximum 999 seconds) with " X,X,X ".
Press " E " to continue to the next soap injection.
Only the blocks of So1, So2 , So5 and So6 are drawn to save space. The others (So3 and So4 ) are identical.
To Next Page
Loading...