7
Classification according to modes 2
As soon as the electric power is connected to the machine, it will carry out a so-called " Eprom test ".
" ProM.XXXX " and " Good.XXXX " will appear temporarily on the display (XXXX stands for the number of the
Eprom version). Then " dAtA.XXXX " appears temporarily. This is the " Checksum " of the total data. This value
changes each time the program is altered.
Then " StArt " appears.
Now choose between 4 different modes.
Remark:
" Error 03 " appears on display when the electrical power is supplied to the machine for the very first time, or when
a fault is found in the Ram memory (memory wash programs). Press E .
Preprogramming mode
In this mode the machine can be initiated into its own technical specifications (e.g. coin-op or manually operated
machine, the number of water inlet valves, machine with or without heating, etc.), as well as into certain freely
programmable options (e.g. temperature in °C or °F, temperature displayed during the cycle or not, etc.).
To get into the "preprogramming mode":
- Set the key switch in the front to " PROG ".
- Put in " E 6 1 9 " (press quickly one after the other)
" ProGrAM " appears on the display. Press " E ".
" PrE " appears on the display.
To alter the "preprogram": see chapter 3.
Remark:
- The preprogram is fixed during assembly of the machine so that it usually needn't be altered anymore.
- If the key switch in the front is not set to " PROG ", " Error = 00 " (flashing) will appear for about 10 seconds after
" E 6 1 9 " is put in.
Programming mode
In this mode you can put in step by step the data necessary to obtain a complete wash cycle of your own choice.
To get into the "programming mode":
- Put the key switch in the front in the " PROG " position.
- Put in " E 4 5 5 ". (Press quickly one after the other)
" ProGr " (flashing) will appear on the display.
To program a wash program: see chapter 4.
Remark:
If the key switch in the front is not set to " PROG ", " Error = 00 " (flashing) will appear for about 10 seconds after
" E 4 5 5 " is put in.
Copying mode
In this mode existing programs can be copied to other program numbers. This can save a lot of work when almost
identical programs need to be programmed.
To get into the "copying mode":
- Put the key switch in the front in the " PROG " position.
- Put in " E 3 2 8 ". (Press quickly one after the other)
" CoPY PrG " will appear on the display.
To copy a program: see chapter 5.
Remark:
If the key switch in the front is not set to " PROG ", " Error = 00 " (flashing) will appear for about 10 seconds after
" E 3 2 8 " is put in.
Operating mode
In this mode an existing wash program can be started.
To get into the "operating mode", press the number of an existing wash program. " ProG XX " will appear on the
display ( XX stands for the selected wash program).
To start the program: see chapter 6.
To Next Page
Loading...