- 32 -
- DHCP: Select this option when your network uses the
DHCP server. When the camera starts up, it will be
assigned an IP address from the DHCP server
automatically.
- Static IP: Select this option to assign the IP address for
the camera directly. You can use IPFinder to obtain the
related setting values.
IP
Enter the IP address of the camera. The
default setting is 192.168.0.30.
Subnet Mask
Enter the Subnet Mask of the camera. The
default setting is 255.255.255.0.
Default
Gateway
Enter the Default Gateway of the camera.
The default setting is 192.168.0.1.
Primary/
Secondary
DNS
DNS (Domain Name System) translates
domain names into IP addresses. Enter the
Primary DNS and Secondary DNS that are
provided by ISP.
- PPPoE: Select this option when you use a direct
connection via the ADSL modem. You should have a
PPPoE account from your Internet service provider. Enter
the User Name and Password. The camera will get an IP
address from the ISP as starting up.
NOTE Once the camera get an IP address from the ISP as starting up,
it automatically sends a notification email to you. Therefore,
when you select PPPoE as your connecting type, you have to
set up the email or DDNS configuration in advance.
DDNS Setting: With the Dynamic DNS feature, you can
assign a fixed host and domain name to a dynamic Internet
IP address. To set up the DDNS:
1. Select the Enable option to enable this feature.
2. Select the Provider from the pull-down list.
3. Enter the required information in the Host Name, User
Name, and Password boxes.
To Next Page
Loading...
Need help?
General
