- 34 -
4.4.3 Network >> IP Filter
The IP Filter setting allows the administrator of the camera to limit
the users within a certain range of IP addresses to access the
camera. To disable this feature, select the Disable option;
otherwise, select the Accept option to assign the range of IP
addresses that are allowed to access the camera, or select the
Deny option to assign the range of IP addresses that are blocked
to access the camera.
Disable: Select this option to disable the IP Filter function of
the camera.
Accept
- IPv4: Assign a range of IP addresses that are allowed to
access the camera by entering the Start IP address and
End IP address options. When you are finished, click Add
to save the range setting. You can repeat the action to
assign multiple ranges for the camera.
- IPv6: Enter the IP Address that is allowed to access the
camera.
Deny
- IPv4: Assign a range of IP addresses that are blocked to
access the camera by entering the Start IP address and
End IP address options. When you are finished, click Add
to save the range setting. You can repeat the action to
assign multiple ranges for the camera.
- IPv6: Enter the IP Address that is not allowed to access
the camera.
For example, when you enter 192.168.0.50/192.168.0.80 in
Start/End IP Address of Accept > IPv4, the user whose IP
address located within 192.168.0.50 ~ 192.168.0.80 will be allowed
to access the camera. On the other hand, if you enter the IP range
in Start/End IP Address of Deny > IPv4, the user whose IP
address located within the range will not be allowed to access the
camera.
To Next Page
Loading...
Need help?
General
