Braava jet™ Owner’s Guide 29
EN
28 For Customer Care go to www.irobot.com/support
EN
Tips for Best Performance
General Cleaning Tips
• For best results, use a Dry Sweeping Pad or vacuum to pick up dirt and dust
before running your robot with a Wet Mopping or Damp Sweeping Pad.
• To pause your robot during a cleaning cycle, press the CLEAN button.
To resume the cleaning cycle, press the CLEAN button again.
• Do not pick up and move your robot while it is cleaning – the robot will
end its cleaning run if you do.
• Always fill Braava jet to the top with water and check for any air
bubbles before closing the tank cap.
• Only use water inside your robot. Cleaning solutions, even natural ones, can
clog the spray nozzle and break down the materials inside the robot.
• Your robot will only run with Braava jet Pads, which are specifically made
for the robot.
• Braava jet cleans best on smooth hard surfaces and may not perform as well on
uneven tiles, heavily waxed floors or rough surfaces like slate or brick which may
snag the cleaning pads.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
