17
PROGRAM CYCLE
Use this feature to manually operate watering programs. You can run the entire program or
start anywhere within the station sequence of the program.
NOTE: Only the stations with an assigned run time in the program will operate during the
program watering cycle.
1. Turn the function dial to the Program Cycle position.
2. Select Program A, B, C or D with the Program switch.
3. Press the NEXT button to select the fi rst station of the watering sequence (if other than
the station number displayed).
4. Press the ON button to start the watering cycle. Watering will start with the selected
station and will be followed by all subsequent stations. The display will show the run
time remaining for the operating station.
NOTE: You may advance through the stations by pressing the NEXT key for the next
station. To terminate operation at any time, press the OFF button.
5. Leave the function dial in the Program Cycle position until the manual operation is
complete, then return the dial to the RUN position.
To Next Page
Loading...
Need help?
General
