16
MANUAL OPERATIONS
Manual operation allows you to run individual stations or start automatic watering
programs as needed. The Total Control provides separate dial positions for each type of
operation: Single Station and Program Cycle.
Single Station
This option enables individual stations to be operated for an untimed duration (turned
On/Off) or operated for a selectable duration from one minute to 10 hours.
1. Turn the function dial to the Single Station position.
2. Select Program
A, B, C or D with the Program switch.
NOTE: The programmed status of the master valve/pump start in the selected program
determines whether the master valve/pump start will be activated with the manual
operation.
3. Use one of the following options to operate the station.
For untimed operation:
a. Press the
NEXT button as necessary to display the station you wish to operate.
b. Press the ON button. The station will turn on and remain on until one of the
following occurs:
• The OFF button is pressed
• The controller clock passes midnight
• The function dial is moved to another position
For timed operation:
a. Press the NEXT button as necessary to display a station you wish to operate.
b. Use the + and/or – buttons to set the desired amount of station run time (for
this operation only), from one minute to 10 hours.
c. To select additional stations to operate in sequence, repeat steps a and b as
desired. Each station will operate one-by-one in the order they were selected.
d. Leave the function dial in the Single Station position until the manual
operation is complete, then return the dial to the RUN position.
To Next Page
Loading...
Need help?
General
