To Next PageTo Next Page
Need help?Do you have a question about the Irritrol KD2 and is the answer not in the manual?
General| Brand | Irritrol |
|---|---|
| Model | KD2 |
| Category | Controller |
| Language | English |
Instructions for mounting the controller cabinet securely to a wall.
Details on connecting valve wires and solenoids to the controller terminals.
Guidance on connecting a pump start relay to the controller's MV terminal.
Steps to connect and configure an optional rain sensor for automatic watering interruption.
Instructions for safely connecting the controller to the AC power source.
Guide to setting the current date and time on the controller.
Advice on preparing a watering schedule before programming the controller.
How to set specific days of the week for watering in each program.
Configuring watering to occur at set intervals (1-31 days) between watering days.
Details on the controller's non-volatile memory and battery backup for date/time.
Selecting watering days based on odd or even numbered days of the month.
Configuring the specific times when automatic watering programs will begin.
Determining how long each station will water for a given program.
How the controller operates automatically based on programmed schedules.
Methods for manually controlling watering operations, overriding automatic settings.
Running a single station manually until turned off or midnight.
Manually operating stations for a set temporary duration in sequence.
Manually starting and operating pre-programmed watering cycles.
Running quick, temporary watering tests for individual stations.
Temporarily delaying automatic watering operations for a set number of days.
Procedure for completely shutting down the controller and preventing watering.
Adjusting station run time duration by percentage for selected programs.
Changing the display format for station run times between minutes or hours/minutes.
Selecting the display language from English, Spanish, or French.
Choosing between 12-hour AM/PM or 24-hour format for time display.
Clearing program data (start times, run times, budget) for selected programs.
Configuring the controller's expansion port for optional accessories like Climate Logic.
Enabling or bypassing the rain sensor input terminals.
Checking the current firmware version installed on the controller.
Explanation of the electronic circuit breaker that protects against station overloads.
