15
Timed Manual Operation
Timed manual operation enables any stations to be given
a temporary station run time duration and operated in
sequence.
1. Turn the control dial to Manual Station position.
2. Press the button until the desired station number is
ashing and the display shows (dashes).
3. Press to turn the station ON. The station will remain
active until the control dial is moved or another station
is selected.
For a specic run time (from 1 minute to 4 hours),
continue to press . Once the run time is set,
press
to activate.
Note: The temporary station run time will not aect the
station’s run time within any automatic program.
4. Repeat steps 2–4 to select additional stations.
(These stations will not start immediately, but will
operate in sequence.)
5. After all desired stations for timed manual operation
have been selected, return the control dial to
HOME position.
• To manually advance through the station sequence,
press the button (the control dial must be in the
HOME position to use this feature).
• To terminate the timed manual operation, either
skip through the remaining station sequence with
the
button, or press the button. OFF will
be displayed. Press
button again to resume
automatic watering.
Manual Program Operation
Manual program operation enables automatic watering
programs to be manually started and operated in
sequence.
1. Turn the control dial to the Manual Programs
position. The display will show MAN, the currently
selected program letter and stations assigned to the
program.
2. Press the button as needed to display a program
you wish to run. All stations which currently have a
station run time duration assigned to the selected
program will be shown at the top of the display.
3. Press the button to start the program (or select
an additional program). The program letter and the
watering symbol
will begin ashing.
4. Repeat steps 2 and 3 to select additional programs to
operate in sequence.
5. Return the control dial to HOME position. The
remaining run time duration for the currently operating
station will be displayed. Station numbers and
programs waiting to run will also be shown.
• To manually advance through the station sequence,
for the program, press the button. If more than
one program was selected, continue pressing the
button to advance to the next program in sequence.
• To terminate the manual program operation, either
skip through the remaining stations and programs
in sequence with the
button, or press the
button. OFF will be displayed. Press button again
to resume automatic watering.
To Next Page
Loading...
Need help?
General
