14
This section includes instructions for the following controller operations:
• % Water Budget
• Program Stacking
• Manual Operations
• Off and Rain Delay Modes
% WATER BUDGET - SEASON ADJUST
The Season Adjust feature enables you to easily increase or decrease the station run time
(by percentage) of all stations assigned to a selected program. This is handy for making
temporary, overall station run time adjustments without changing the original run time
settings. % Season Adjust values range from 0 to 200% in 10% increments, with 100%
being the normal setting.
For example, as the fall season approaches and the temperature decreases, you may want to
reduce the station time for the stations in program A by 30%. Later you can return station
times to their original values by setting the % Season Adjust value back to 100%.
NOTE: It is possible to inadvertently cause start time stacking when increasing station run
time. Careful planning and use of % Season Adjust will prevent this from happening.
To change the Season Adjust percentage value of a selected program:
1. Turn the function dial to the % Water Budget position.
2. Select Program A, B, C or D with the Program switch.
3. Use the + and/or – buttons to increase or decrease the percentage value (0–200%).
4. Turn the function dial to the RUN position .
NOTE: The controller displays the % symbol in the RUN position when %
Season Adjust is in use for any program. During operation, the adjusted run time will be
displayed.
OPERATING THE CONTROLLER
To Next Page
Loading...
Need help?
General
