DOC. MIE91093 Rev. 1.34 Page 13 of 145
In this situation it is possible to connect resistors in series;
however, one must be careful not to exceed the maximum
current rating, and the wiring is more complicated. The
solution to this problem is just to reduce the available power:
this is easily performed via the multi-function knob. With less
power, the maximum voltage is reduced by a factor of 4.4; the
adjustment span on the knob is increased accordingly.
Additional features are:
. Two meters, current and voltage, with independent inputs,
allow measuring T1000 PLUS outputs or any other source;
. Two auxiliary contacts, that switch at test start, and reset
with STOP input, allows simulating the circuit breaker;
. A set of resistors allows easing output adjustment.
The instrument is housed in a transportable aluminum box,
that is provided with removable cover and handles for ease of
transportation.
NOTE: WINDOWS is a trademark of MICROSOFT inc.
To Next Page
Loading...
