15
VI. MAINTENANCE
General Guidelines
• Avoid knocking or bumping the tiller and controls.
• Avoid prolonged exposure of your scooter to extreme conditions,
such as overheat, cold, or moisture.
• Keep the control panel clean.
• Make sure all connectors are tight and secured properly.
• Check all electrical connectors, including the charger’s connectors.
Make sure they are all tight and are not corroded. The battery pack
must sit flat in the battery tray with the battery terminals facing
backward and forward each other and with the 3-pin charging port
backward.
• After each use, remove the key to reduce unnecessary battery drain.
• This product has a power saving device. When you do not use it
for up to 20 minutes, the power will shut off automatically. To drive
again, please re-plug the key.
• The body shroud has been sprayed with a clear sealant coating,
and you can apply a light coat of car wax to help it retain its
high-gloss appearance.
• All wheel bearings are pre-lubricated and sealed. They require no
subsequent lubrication.
• To keep your scooter in a better condition, it should be checked
before using. It is suggested that your scooter should be checked
once per week and half a year as the following table.
To Next Page
Loading...
