Need help?Do you have a question about the ISDT D2 Mark II and is the answer not in the manual?
Port for AC power connection.
USB output port for charging other devices.
Port for firmware updates.
Balance connector for Channel 1.
Main power connector for Channel 1.
Main power connector for Channel 2.
Balance connector for Channel 2.
Button to select Channel 1.
Button to select Channel 2.
Main screen for information display.
Navigation and selection control key.
Configure charger for parallel task mode, outputting max power to one battery.
Configure charger for dual task mode, operating both channels simultaneously.
Use CH1 as a DC power supply with adjustable voltage and current.
Port for AC power connection.
USB output port for charging other devices.
Port for firmware updates.
Balance connector for Channel 1.
Main power connector for Channel 1.
Main power connector for Channel 2.
Balance connector for Channel 2.
Button to select Channel 1.
Button to select Channel 2.
Main screen for information display.
Navigation and selection control key.
Configure charger for parallel task mode, outputting max power to one battery.
Configure charger for dual task mode, operating both channels simultaneously.
Use CH1 as a DC power supply with adjustable voltage and current.
General| Output Power | 200W |
|---|---|
| Max. Charge Power | 200W |
| Discharge Current Range | 0.1-5A |
| Display Resolution | 320x240 |
| Weight | 500g |
| Discharge Current | 5A |
| Balance Current | 500mA |
| Supported Battery Types | LiPo, LiHV, LiFe, NiMH, NiCd, Pb |
| Cell Count | 1-6 cells |
| Balance Port Current | 500mA |
| Operating Temperature | 0-40°C |
| Storage Temperature | -20℃-60℃ |
| Cooling System | Fan |
| Charge Current Range | 0.1-10A |
To Next Page
