Need help?Do you have a question about the ISHIDA MTX-150Kg and is the answer not in the manual?
Follow the steps below to set up and calibrate the NOVA-II scale.
Follow the steps below to set up and calibrate the Ishida BC-3000 scale.
The MTX and MTB Series scales have the same configuration and setup procedures.
Follow the steps below to set up and calibrate the MTE Series scale.
The MG-3000 uses one of two CPU boards. Calibration procedures differ.
Follow the KG and GRAM Calibration Procedure for the CWS Series scale.
Follow the LB and OZ Calibration Procedure for the CWS Series scale.
Follow the steps below to set up and calibrate the NCS Series scale.
Follow the steps below to set up and calibrate the QBX Series scale.
Follow the steps in the table below to set up and calibrate the QB Series scale.
NOTE: MB Series scales cannot be calibrated. They are stamped or sealed by local weights/measurement offices.
Follow the steps in the table below to set up and calibrate the MB-RE Series scale.
Follow the steps below to set up and calibrate the Ishida IB Series scale.
Follow the steps to set up and calibrate the Ishida SB Series scale.
To Next Page
General
