7
● Find the rack and put it over the rear
fender. Find the screw holes and tighten the
screws and nuts on the seat stays. Pass the
screws through the holes of the rack bottom
eyelets and the fender brace eyelets in
sequence, and tighten the screws on both
sides.
● Find the pump from the box to inflate
the tyres. Inflate 280-450 kPa (40-65 psi /
2.8-4.5 bar) air.
Note: Do not over inflate tyres to prevent
flat tyres. You can check the tyre pressure
by squeezing the tyres by hand.
● Connect the light cable’s male connector
to the cable’s female connector from the
controller.
3.8 Inflate the front and rear tyres
To Next Page
Loading...
