1A-338 Engine Control System (4HK1)
4
1. Inspect the following conditions:
• Misrouted or disconnected exhaust
differential pressure hoses or pipes
Important: There is installation
directionality in the exhaust differential
pressure hoses. Refer to Exhaust
System in Section 1G Engine Exhaust .
• Plugged, crushed or kinked exhaust
differential pressure hoses or pipes
• Dislocated or inclined exhaust differential
pressure sensor. Refer to Exhaust
System in Section 1G Engine Exhaust .
• Physical damage of the exhaust
differential pressure sensor
• Any contamination or objects that block
the exhaust differential pressure sensor
port
• Skewed or slow exhaust differential
pressure sensor
• An exhaust system gasket that is missing
or damaged
• Exhaust gas leakage from the exhaust
pipe, gasket, DPD assembly, exhaust
temperature sensor(s) or exhaust
differential pressure hoses or pipes
• Modified exhaust system
• Exhaust throttle valve or exhaust brake
valve for stuck condition. Refer to
Exhaust System in Section 1G Engine
Exhaust.
• Skewed or slow exhaust temperature
sensors
• Restricted air cleaner element, restricted
or collapsed air tubing between the air
cleaner and the intake manifold
• Modified air induction
• Any air induction leak
• Any contamination or objects that block
the mass air flow (MAF) sensor inlet
• Skewed or slow MAF sensor
2. Repair or replace as necessary.
Did you find and correct the condition?
—
Go to Step 14 Go to Step 5
5
Start the engine and let idle for 30 seconds.
Does the DPD lamp or “PUSH DPD SWITCH”
indicator blink?
—
Go to Step 6 Go to Step 7
6
Perform the DPD manual regeneration by pressing
the DPD switch.
Does the regeneration start?
—
Go to Step 10
ECM is not allowing
the DPD
regeneration
control. Refer to
Test Description and
DTC List
7
Observe the DPD Accumulation Status and DPD
Distance Status with a scan tool, and plot both
readings on the DPD status table.
Is the intersected range located in A or B?
—
Go to Step 8 Go to Step 9
Step Action Value(s) Yes No
LG4HKED-WE-0871.book 338 ページ ２００７年１１月２９日 木曜日 午後６時２９分
To Next Page
Loading...