What to do if all lines are connected but there is no sound from ITC T-4120UC Amplifier?
If all lines are connected, but there is no sound, here are a few things to check: * Ensure the power switch is on and the power plug is securely connected. * Replace the burnt fuse. * Adjust the volume knob to an audible level. * Check the audio signal input. * Inspect the speaker line for short-circuits.
Why does the sound suddenly disappear on my ITC T-4120UC Amplifier?
If the sound suddenly disappears, it could be due to the equipment overheating and entering protection mode. Allow the equipment to cool down. Another potential cause is a bad connection in the wiring. In this case, fix the bad contact in the connection wire.
How to fix distorted sound on ITC T-4120UC?
If the sound is distorted, the input level of the Mic or external equipment may be too high. Lower the input level of the Mic or external equipment.
What causes low sound on ITC Amplifier?
If you are experiencing low sound, it could be that the equipment is set to low impedance connection, but the speakers connected are with high impedance. To resolve this, change the connection settings to match speaker impedance.
What to do if the ITC T-4120UC Amplifier power switch is not opened?
If the power switch is not opened, check the power line. Also, verify if the protection function needs to be activated.
General| Power Output | 120W |
|---|---|
| Power Consumption | 180W |
| Speaker Output | 4-16Ω |
| SNR | ≥70dB |
| THD | ≤0.5% |
| Tone | Bass: ±10dB at 100Hz, Treble: ±10dB at 10kHz |
| Protections | Overload, Short Circuit |
| Power Supply | AC 220V, 50/60Hz |
| Input Impedance | Line: 10kΩ |
To Next Page
