ITC TI-1206S User Manual (English)

Questions and Answers:

J
Jonathan MaddoxAug 11, 2025
What to do if ITC TI-1206S has all lines connected but no sound?
- M
  Morgan HernandezAug 11, 2025
  If your ITC Amplifier has all lines connected but there is no sound, there could be several reasons. First, ensure the power switch is turned on and check the power plug. Next, inspect the fuse and replace it if it's burnt. Also, make sure the volume knob is properly adjusted and not set too low. Verify that there is an audio signal input and check the speaker line for any short-circuits.
V
vancedonaldAug 16, 2025
Why does the sound suddenly disappear on my ITC Amplifier?
- S
  Steven AyalaAug 16, 2025
  If the sound suddenly disappears on your ITC Amplifier, it could be due to the equipment overheating and entering protection mode. Allow the equipment to cool down. Another possible cause is a bad connection wire, so check all connection wires to ensure they are properly connected.
C
Clarence WatkinsAug 23, 2025
How to fix distorted sound on ITC TI-1206S?
- J
  John ArmstrongAug 23, 2025
  If the sound from your ITC Amplifier is distorted, the input level of the microphone or external equipment might be too high. Try lowering the input level to resolve the distortion.
N
nathanortizAug 28, 2025
What to do if ITC TI-1206S Amplifier has low sound?
- B
  bridgetharrisAug 28, 2025
  If your ITC Amplifier has low sound, the equipment might be set to low impedance connection while the connected speakers have high impedance. Adjust the impedance settings to match your speakers.
P
peter13Sep 3, 2025
What to do if ITC TI-1206S Amplifier power switch is not opened?
- W
  William CoxSep 3, 2025
  If the power switch of your ITC Amplifier is not working, check the power line to ensure it is properly connected. Also, ensure that the protection function of the equipment is activated.