ITech IT-M7700 Programming Guide

LIST Subsystem(IT-M7700)
Copyright© Itech Electronic Co., Ltd. 65
Arguments
Description
Step index
value
Set the current Step number.
Type
Set the single step type: 0：Time.
Wave Type
Set the single-step waveform type: 0~39.
⚫ 0：Sine
⚫ 1：Square
⚫ 2：Triangle
⚫ 3：Saw
⚫ 4：Clip Sine
⚫ 5~34：THD1~THD30
⚫ 35~39：USER1~USER5
Level
Set the clipping percentage. This option is only valid when
the Clip Sine output waveform is selected.
Vac
The AC voltage value set in a single step.
Vdc
The DC voltage value set in a single step
Freq
The frequency value set in a single step.
Time
Dwell time for single step: 0~100000000ms.
Start Phase
Start phase angle of single-step waveform.
Stop Phase
Stop phase angle of single-step waveform.
Kac
AC rising slope of single step.
Kdc
DC rising slope of single step.
Kfreq
Frequency rising slope of single step.
Repeat
Set the number of repeats for the step: 1-50,000.
NOTE
The minimum unit of Kac, Kdc, Kfreq is mS (millisecond), these three parameters are the
parameters of the unit time variation. When these three parameters are set, the decimal point
will be automatically rounded off. When these three parameters are 0, it represents the fastest
change.
Syntax
LIST:RECOrder <NR1>,<String>

ITech IT-M7700 Specifications

General

Brand	ITech
Model	IT-M7700
Category	Portable Generator
Language	English