Power Supply Function
• V4: Voltage in interval 4
• V5: Voltage in interval 5
• V6: Voltage in interval 6
lower-
limited
Range of lower limited operating ca-
pability, with the following settings:
• V1: Voltage in interval 1
• V2: Voltage in interval 2
• V3: Voltage in interval 3
• V4: Voltage in interval 4
• V5: Voltage in interval 5
• V6: Voltage in interval 6
highly-
limited
Range of highly limited operating ca-
pability, with the following settings:
• V1: Voltage in interval 1
• V2: Voltage in interval 2
• V3: Voltage in interval 3
• V4: Voltage in interval 4
• V5: Voltage in interval 5
start
voltage
Set the initial output voltage of the in-
strument before the LV123 regulation
waveform test. At the same time, this
value is also the end voltage after the
regulatory waveform test is
completed.
start
time
Test time of starting voltage, range:
0~999.999S.
end time Test time of end voltage, range:
0~999.999S.
count Set the number of test repetitions,
ranging from 1 to 65535. The actual
number of test executions = count *
3.
Save To
File
Set the save address of the waveform
file, range: 1~10.
Copyright © Itech Electronic Co., Ltd.
93
To Next Page
Loading...
Need help?
General
