ITech IT6302 - Page 21

IT6302 user manual
USER MANUAL
21
at power on.
Last
“remember” output On/Off state
before power off
Beep
OFF
Disable buzzer
ON
Enable buzzer
BAUD
4.8
Baudrate 4800
9.6
Baudrate 9600
38.4
Baudrate 38400
Grp
Grp1
Save to group1
Grp2
Save to group2
Grp3
Save to group3
COUP
Configure connection mode between
CH1&CH2
OFF
Ser
Configure for serial operation
Par
Configure for parallel operation
TRAC
Set the tracking mode of CH1&CH2
OFF
Disable tracking function
ON
Enable tracking function
Out
This parameter sets the output On/Off state at power up. If you select “Last”, the power
supply will save the output state prior to power down and revert to that state at power up.
If you select “Off”, the output state is always “OFF” when the power supply is turned on.
The recommend setting is “OFF”.
Beep
This parameter turns the beep sound for key presses “On” or “Off”.
When switch power supply between CV and CC mode, the enabled buzzer will beep two
sounds.
BAUD
This parameter configures the baudrate for serial communication. Possible values are
4800,9600,19200 or 38400.
When operating the power supply in remote mode, make sure that you configure identical
baudrate settings for the power supply and the computer.
Grp