Measurement Commands
Copyright © Itech Electronic Co., Ltd. 27
Chapter9 Measurement Commands
MEASure:CURRent?
This order is used to measure and return output current value.
Order syntax
MEASure[:SCALar]:CURRent[:DC]?
Return parameters
<NR2>
FETCh:CURRent?
This order is used to read the latest current to be processed from sampling
buffer. When you send this order, then our unit will communicate with PC, and
sending the current data to PC. This order will not affect our unit’s setting or
trigger the measurement operation. It only needs the nearest reading it can get.
The returned readings will keep the old before it get a new data.
Order syntax
FETCh:CURRent[:DC]?
Return parameters
<NR2>
MEASure[:VOLTage]?
This order can inquire the current output voltage value.
Order syntax
MEASure[:SCALar][:VOLTage][:DC]?
Return parameters
<NR2>
FETCh[:VOLTage]?
This order is used to read the latest preprocessed voltages from sampling
buffer.
Order syntax
FETCh[:VOLTage][:DC]?
Return parameters
<NR2>
To Next Page
Loading...
