To Next Page

To Previous Page

Calibration Commands

Chapter11 Calibration Commands

CALibration:SECure:[STATe]

Set protection mode enable or disable when calibrating the power supply.

Order syntax

CALibration:SECure:[STATe] {<ON|OFF>[<password>]}

Parameters

0|1|ON|OFF 'XXXX’

Example

CAL:SEC 1 'XXXX’; //XXXX is the instrument model

CAL:SEC OFF

Query syntax

CALibration:SECure:STATe?

CALibration:INITital

This order is used to reset the calibration parameters to default setting.

Order syntax

CALibration:INITital

Parameters

None

CALibration:SAVe

This order is used to save the calibration parameters in a nonvolatile memory.

Order syntax

CALibration:SAVe

Parameters

None

CALibration:VOLTage:LEVel

This order can set voltage calibration point. P1, P2, P3 and P4 must be

calibrated orderly.

Order syntax

CALibration:VOLTage:LEVel <point>

ITech IT6833A Programming Guide

Other manuals for ITech IT6833A