To Next Page

To Previous Page

Current Control Commands

Chapter7 Current Control Commands

CURRent {<current

value>|MINimum|MAXimum|UP|DOWN|DEF}

This order is used to set the output current. No matter what the current range

you select currently, the output current is subject to the newest setting value.

Besides, MIN and MAX can be used as parameters. MIN represents 0A,MAX

represents the max value of the current range. You may send CURR? MIN or

CURR? MAX orders to quire the minimum and maximum current within the

range. DEF represents default value, it also can be used to set value.

We can also send CURR UP and CURR DOWN orders to increase or decrease

current, the stepping value should be set with order ” CURR:STEP”. If adjusted

value has exceeded the current range, then error information will be

return:error-222.

Oder syntax:

[SOUR:]CURR[:LEVel][:IMMediate][:AMPLitude] <NRf>

Parameters:

MIN to MAX

Unit:

*RST value:

MIN

Query syntax:

CURRent? [MINimum|MAXimum]

Return parameters:

<NR2>

Example:

CURR:STEP 0.01 //set the stepping value to be 0.01A

CURR UP //enable the output current increase value one time

CURR:STEP 0.02 // set the stepping value to be 0.02A

CURR DOWN // enable the output current decrease value one time

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT6932A Programming Guide

Other manuals for ITech IT6932A