To Next Page

To Previous Page

Voltage Control Commands

Chapter8 Voltage Control Commands

VOLTage

{<volts>|MINimum|MAXimum|UP|DOWN|DEF}

This order is used to set the output voltage. No matter what the voltage range

you select currently, the output voltage is subject to the newest setting value.

Besides, MIN and MAX can be used as parameters.MIN represents 0V,MAX

represents the max value of the voltage range. You may send VOLT? MIN or

VOLT? MAX orders to quire the minimum and maximum voltage within the

range. DEF represents default value, it also can be used to set value.

We can also send VOLT UP and VOLT DOWN orders to increase or decrease

voltage, the stepping value should be set with order ” VOLTage:STEP”. If

adjusted value has exceeded the voltage range, then error information will be

return:error-222.

Order syntax:

[SOUR:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf>

Parameters:

MIN to MAX

Unit:

*RST value:

MIN

Query syntax:

VOLTage? [MINimum|MAXimum]

Return parameters:

<NR2>

Example:

VOLT:STEP 0.01 //set the stepping value to be 0.01V

VOLT UP //enable the output voltage increase one time

VOLT:STEP 0.02 //set the stepping value to be0.02V

VOLT DOWN //enable the output value decrease one time

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT6932A Programming Guide

Other manuals for ITech IT6932A