ITech IT8511A+ - Chapter 4 Automatic Test Function; Introduction; Automatic Test Mode Switching

Input Settings
Copyright © ITECH Electronic Co., Ltd. 35
*RST Value
MAXimum
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude]
<NRf+>
This command is used to set the power setting in CP mode.
Command Syntax
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude] <NRf+>
Parameters
MIN~MAX|MINimum|MAXimum
Unit
W
*RST Value
MINimum
Examples
POW 10
Query Syntax
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude]?
Returned Parameters
<NR2>
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude]?
This command is used to query the power setting in CP mode.
Command Syntax
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude]?
Parameters
None
Unit
W
*RST Value
MINimum