ITech IT8516C+ Programming Guide

Input Settings
Copyright © ITECH Electronic Co., Ltd. 31
Command Syntax
[SOURce:]VOLTage[:LEVel]:ON?
Unit
V
*RST Value
1
[SOURce:]Voltage:[LEVel:]OFF <NRf+>
This command is used to set the load start unloading voltage value.
Command Syntax
[SOURce:]VOLTage[:LEVel]:OFF <NRf+>
Parameters
MIN ~ MAX | MINimum | MAXimum
Unit
V
*RST Value
0.5
Examples
VOLT:OFF 2
Query Syntax
[SOURce:]VOLTage[:LEVel]:OFF?
Returned Parameters
<NR2>
[SOURce:]Voltage:[LEVel:]OFF?
This command is used to query the load start unloading voltage value.
Command Syntax
[SOURce:]VOLTage[:LEVel]:OFF?
Unit
V
*RST Value
0.5

ITech IT8516C+ Specifications

General

Model	IT8516C+
Category	Test Equipment
Output Current	0-120A
Voltage Resolution	10mV
Current Resolution	1mA
Resolution	10mV/1mA
Interface	USB, RS232, GPIB (optional)
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Operating Mode	CC, CV, CR, CP