IEEE488 Commands
Copyright © ITECH Electronic Co., Ltd. 66
Returned Parameters
<NR1>
Related Commands
*ESR? *PSC *STB?
*ESE?
This query reads the Standard Event Enable register.
Command Syntax
*ESE <NRf>
Returned Parameters
0 to 255
Default value
see *PSC
*ESR?
This query reads the Standard Event Status Event register. Reading the register
clears it. The bit configuration of this register is the same as the Standard Event
Status Enable register (see *ESE). See chapter “Programming the Status
Registers” for a detailed explanation of this register.
Query Syntax
*ESR?
Parameters
None
Returned Parameters
<NR1> (register value)
Related Commands
*CLS *ESE *ESE? *OPC
*IDN?
This query requests the electronic load to identify itself. It returns the data in
four fields separated by commos.
Query Syntax
*IDN?
Parameters
None
To Next Page
Loading...
Need help?
General
