Remote Control
Copyright © Itech Electronic Co., Ltd. 8
The device is RL1 capable.
The device is DT1 capable.
1.6.2 GPIB Interface
First connect GPIB port of load to GPIB card of PC with IEEE488 BUS. They
must be sufficient contact and tighten the screws. And then set address. The
address can be set from 0 to 30. Press [Menu] key to enter system menu,
press [COMM CONFIG] to find Communication interface. Select GPIB, and
then set the GPIB address, press [Enter] to confirm. The electronic load
operates from a GPIB address set from the front panel. The GPIB address is
stored in non-volatile memory.
1.6.3 LAN Interface
Press [Menu] on the front panel together to access the menu. Select [COMM
CONFIG] to enter communication configuration page. Select LAN by pressing
arrow keys and then configure Gateway, IP, Mask and Socket Port in the LAN
option. Use a cross network cable through LAN interface to connect PC.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
