ITech IT8625 Programming Guide

Measurement Commands
Copyright © Itech Electronic Co., Ltd. 18
Parameter:
FUNDamental|TOTal|ALL| or <NR1>
Returned value:
<NR3>
FETCh:PHASe:HARMonic?
This command is used to read all the phase of harmonic measurement
Command syntax:
FETCh:PHASe:HARMonic? <ALL or NR1>
Parameter:
ALL or NR1
Returned value:
<NR3>
FETCh:VOLTage:HARMonic:DISTort?
This command is used to read the percentage of each harmonic.
Command syntax:
FETCh:VOLTage:HARMonic:DISTort? <TOTal|ALL or NR1>
Parameter:
TOTal|ALL or NR1
Returned value:
<NR3>
FETCh:HARMonic?
This command is used to read all the harmonic data.
The order of returned data is the absolute value of total harmonic, the total
harmonic component, the fundamental frequency, and each range is as follows:
 The absolute value of 0-50 times voltage harmonic.
 0-50 times voltage harmonic component
 0-50 times harmonic phase angle
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 Specifications

General

Brand	ITech
Model	IT8625
Category	Test Equipment
Language	English