Basic Operations
Copyright © ITECH Electronic Co., Ltd. 39
⚫ Y-type connection
⚫ Δ-type connection
Configure the internal relationship of instruments after connecting the system
bus.
The configuration interface of IT8620 series and IT8615/IT8615L are not the
same. The specific setting steps are as follows.
⚫ Take the example of IT8615 electronic load
During the three-phase setting, firstly, the user must set three electronic loads
to be one master and two slaves. Then the user can configure the phase of
three electronic loads in master.
Select two electronic loads as the slaves.
1. Press [Menu] to enter the system menu setting interface.
2. Select [PARALLEL SETUP] to enter the parallel setting interface.
3. Press the Up and Down key to select the “Operating Mode” > “Parallel”.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
