ITech IT8625 User Manual

Waveform Display Function
Copyright © ITECH Electronic Co., Ltd. 66
Parameter Name
Description
SINGLE
Single measurement key: when single
measurement is enabled in the Stop status, the
stop status is enabled again after one
measurement based on the current data updating
rate. When single measurement is enabled in the
Run status, the instrument immediately restarts
one measurement and then enters the Stop
status.
WAVE(U/A/UA)
Used for selecting the waveform to be displayed
on the screen: voltage, current and
voltage/current.
AUTO
Automatic adjustment key: when the
corresponding soft key is pressed, the input signal
of the power meter will be calibrated automatically
to display the best effects of input signals.
TRIG SETUP
Trigger setting.
MEASURE SETUP
Measurement setting
Introduction to waveform display interface
Description of the trigger state:
Trigger
State
Description
Auto
The selected trigger mode is “Auto”. After triggering, the trigger
state “Auto” appears.
Auto?
The selected trigger mode is “Auto”. The trigger state is “Auto?”
if triggering is not performed.
Trigger
level
V/I grid
Trigger
delay
Delay time
Time
grid
Trigger
state
The voltage/current difference
between ground level and point
of center vertical
wave
Measuring
parameters
Trigger
level
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 Specifications

General

Brand	ITech
Model	IT8625
Category	Test Equipment
Language	English