ITL HD 7515 - Operating Instructions; Hose Hook-Up & Inlets

gure 8
14
Operating Instructions
Hose Hook-up & Inlets
Before operating your central vacuum…
Please verify that your central vacuum is properly connected to the piping
system, and to a grounded electrical outlet, and that the low voltage wires
are connected to the unit (see pages 8 to 13). Then, read the complete
owner’s manual and proceed with a quick verication of your unit’s
installation :
• Checkbagandltertomakesuretheyareproperlyinstalledandnot
damaged.
• Checkrubbersealsineachvacuuminlet.
To start your central vacuum, simply insert the hose in the vacuum inlet of
your choice. Please ensure that the tab on the hose end is properly lined
up with the slot in the inlet opening
(gure 8). If your hose handle has an
integrated on/off switch, simply slide the switch to the “on” position.
Do not try to open another inlet while your system is in operation, as it may
damage the inlet’s rubber seal.
• Whilethehoseisstillpluggedintooneinletandthesystemis
operational, check other inlets for leaks.
• Plugthehosealternativelyintoeachvacuuminlet,toensurethateach
one works properly.